Reverb; Chorus - Rodgers Trillium T967 Owner's Manual

Reverb

An independent reverb level (from 0-127) may be set for each MIDI coupler. This value
controls the reverb within the MIDI device itself, not the RSS
within the organ.
Setting the Reverb Level for a MIDI Coupler
To set the Reverb value for a MIDI coupler:
1. Hold SET and press the MIDI coupler piston. (The MIDI coupler will flash).
2. Rotate the Select knob to highlight the Reverb parameter in the display:
3. Rotate the Alpha dial select the desired Reverb value.
4. Press either the flashing MIDI coupler or General Cancel ('0') to exit.
The Reverb selection procedure is complete. Combination pistons which are set
while the MIDI coupler is activated will also store the Reverb value. A MIDI Save
may be performed to save this setting as the default. See "MIDI Save" on page 80.
Instead of saving, you may press and hold General Cancel ('0') and momentarily press
!
SET to return MIDI couplers to their defaults. This Reset procedure also returns
Voice Palette selections to their defaults.
To avoid possible distortion, do not use very high reverb levels.

Chorus

An independent chorus level (from 0-127) may be set for each MIDI coupler. Chorus adds a
slight pitch fluctuation to a given sound; it is often used for guitar and electric piano tones.
Setting the Chorus Level for a MIDI Coupler
To set the Chorus level for a MIDI coupler:
1. Hold SET and press the MIDI coupler piston. (The MIDI coupler will flash).
2. Rotate the Select knob to highlight the Chorus parameter in the display:
M I D I C o u p l e r G T A
P a n
F o o t S w
R e v e r b
67

Room Modeling system
0
O F F
0