Table of Contents
Advertisement
2. Turn the Select Knob clockwise (right) until the cursor moves to the SUSTAIN parameter
(check the menu display for this)
3. Rotate the Alpha Dial to the desired setting (ON/OFF)
4. Press either the flashing MIDI coupler or the General Cancel to exit.
Note: A MIDI Save may be performed to save this setting as the default. See MIDI Save on page
41. Instead of saving, you may press and hold (0) and momentarily press SET to return MIDI
couplers to their last saved status. This also returns stop tab Voice Palette selections to their
defaults.
Reverb
An independent reverb level (from 0-127) may be set for each MIDI coupler. This value controls
the reverb within the MIDI device itself, not the RSS
potential distortion, avoid very high reverb levels
Setting the Reverb Level for a MIDI Coupler
1. Hold the SET piston and press the MIDI coupler piston.
2. Turn the Select Knob clockwise (right) until the cursor moves to the REVERB parameter.
3. Rotate the Alpha Dial to the desired setting (0-127).
4. Press either the flashing MIDI coupler or General Cancel to exit.
Note: A MIDI Save may be performed to save this setting as the default. See MIDI Save on page
41. Instead of saving, you may press and hold (0) and momentarily press SET to return MIDI
couplers to their last saved status. This also returns stop tab Voice Palette selections to their
defaults.
Chorus
An independent chorus level (from 0-127) may be set for each MIDI coupler. Chorus adds a
slight detuning and fluctuation within a given sound and is very effective for guitars and electric
pianos.
M I D I C o u p l e r G T A
V e l o c i t y
S u s t a i n
R e v e r b
system within the organ. To avoid
M I D I C o u p l e r G T A
V e l o c i t y
S u s t a i n
R e v e r b
33
6 4
O F F
0
6 4
O F F
0
Advertisement
Table of Contents
