Table of Contents
Advertisement
4. Release the SET piston.
5. If the tremulant you want to change is already selected in the display (GT MAIN
or "Great Main" in the screen shown above), go to step 6. If not, turn the Select
knob to highlight the tremulant name, then rotate the Alpha-Dial until the
tremulant you want to change is shown in the display.
6. Turn the Select Knob and highlight the value for Depth or Rate.
7. Rotate the Alpha Dial until you achieve the desired result; the range for each of
these settings is from –9 to +9. You can preview your changes by selecting a
corresponding stop and playing a note while making an adjustment.
!
These settings are retained when the instrument is turned off.
TUTTI Settings
The flexible computer-based control system of the T967 allows you to easily view and change
the contents of Tutti I and Tutti II, if desired. In addition, you can always restore the Tutti
contents to factory defaults.
Viewing Tutti Setting
Normally, stops stored in a Tutti do not light when the control is activated.
To cause all stored stops and couplers to light so that either Tutti can be viewed:
1. Press and hold the TUTTI I or TUTTI II piston.
2. While holding the piston, press SET. The stops and couplers contained in the
Tutti will light.
3. Press General Cancel ('0') to return to the Transposer menu.
Unlocking or Locking Tuttis
The Tutti controls are usually locked to prevent accidental changes. Before they can be
programmed, they must be unlocked. After they have been changed, it's also a good idea to
lock them again.
To unlock or lock both Tuttis:
1. Press and hold the TUTTI I or TUTTI II piston for approximately five seconds;
TUTTI LOCKED or TUTTI UNLOCKED appears in the Console Display.
2. If desired setting (Unlocked/Locked) appears in the display, release the Tutti
piston. Otherwise, go to step 3.
3. While continuing to hold the Tutti piston, rotate the Alpha dial in either direction
to change the setting.
26
Advertisement
Table of Contents
