Table of Contents
Advertisement
Hardware Description
8.3.4 UART Configuration
The UART for the CC2564MODNEM board can be routed to the EM or COM connector. The signals are also
available to the debug header to probe the signals.
configuration, where the dotted line shows that the COM connector is not connected. To configure the COM
connector for UART, remove or unpopulate the U3 level shifter as shown in
dotted to represent the unpopulated level shifter.
EM
Connector
EM
Connector
®
14
Dual-Mode Bluetooth
CC2564 Module Evaluation Board
Figure 8-5
Level
UART
Shifters
COM
Connector
Figure 8-5. UART Default Configuration
Level
UART
Shifters
COM
Connector
Figure 8-6. UART COM Connector Configuration
Copyright © 2021 Texas Instruments Incorporated
shows the EM connector as the default UART
Figure
8-6, where the level shifter is
(Default)
UART
UART
CC2564MODN
UART
(Default)
UART
UART
CC2564MODN
UART
SWRU390A – AUGUST 2014 – REVISED AUGUST 2021
www.ti.com
Submit Document Feedback
Advertisement
Table of Contents
