Table of Contents
Advertisement
Note: Fuel fired heater may trigger false
alarms. If you are using the fuel fired heater,
direct the air flow towards the foot well.
Battery Back-up Sounder
The battery back-up sounder is an
additional alarm system that will sound a
siren when the alarm is triggered. When
you lock your vehicle the system is armed.
The sounder has its own battery and will
sound an alarm siren even if someone
disconnects your vehicle battery or the
battery back-up sounder itself.
Triggering the Alarm
Once armed, the alarm is triggered in any
of the following ways:
•
If someone opens a door or the hood
without a valid key or remote control.
•
If someone removes the multi-function
display.
•
If you switch the ignition on without a
valid key.
•
If the interior sensors detect movement
within your vehicle.
•
On vehicles with a battery back-up
sounder, if someone disconnects your
vehicle battery or the battery back-up
sounder itself.
If the alarm is triggered, the alarm horn will
sound for 30 seconds and the hazard
warning flasher will flash for five minutes.
Any further attempts to perform one of the
above will trigger the alarm again.
Full and Reduced Guard
Full Guard
Full guard is the standard setting.
In full guard, the interior sensors are on
when you arm the alarm.
Ranger (TKE) Vehicles Built From: 01-12-2014, DB39-120609-JB enAUS, First Printing
Security
Note: This may result in false alarms if
animals or moving objects are inside your
vehicle.
Reduced Guard
Note: To switch this feature on or off, see
an authorized dealer.
In reduced guard, the interior sensors are
off when you arm the alarm.
Note: Reduced guard is available only on
vehicles with remote central locking.
Note: You can set the alarm to reduced
guard for the current ignition cycle only. The
alarm will reset to full guard the next time
you unlock and then relock the vehicle with
the remote control.
Selecting Full or Reduced Guard
To activate reduced guard, lock the doors
with the key.
To deactivate reduced guard, unlock the
doors with the key or remote control.
To activate full guard, lock the doors with
the remote control.
Note: You can set the alarm to reduced
guard for the current ignition cycle only. The
alarm will reset to full guard the next time
you unlock and then relock the vehicle with
the remote control.
Arming the Alarm
To arm the alarm, lock your vehicle. See
Doors and Locks (page 30).
Disarming the Alarm
Disarm and silence the alarm by unlocking
the doors with the key and switching the
ignition on with a correctly coded key
within 12 seconds or unlocking the doors
with the remote control.
34
Advertisement
Table of Contents
Troubleshooting
