Ford RANGER 2012 Owner's Manual page 19

The bolt thread should protrude at least
10mm beyond the spacer with the lock
washer, anchor fitting and spacer
assembled together.
Tighten the bolt with the anchor fitting
facing toward the front of the vehicle as
shown.
WARNING
Do not over-tighten the attachment
bolt. Maximum torque: 20 Nm
The diagram below shows the correct
installation and orientation of the
attaching clip and anchor fitting.
E212688
Illustrations of the restraint attaching clip
and anchor fitting are only applicable to
child restraints conforming to Australian
Standard AS1754-2004 (or later) . If your
child restraint does not have an approved
latched hook attachment clip as shown,
you should consult an approved Restraint
Fitting Station.
WARNINGS
Always ensure that the attaching clip
is properly engaged with the anchor
fitting and the tether strap length is
adjusted to remove any slack.
Ranger (TKE) Vehicles Built From: 01-12-2014, DB39-120609-JB enAUS, First Printing
Child Safety
Always ensure that the locking
mechanism of the rear seat back is
fully engaged when in the upright
position, by attempting to pull it down
again.
Do not attach a tether strap to
anything other than the correct
tether anchor point.
Make sure that the seat back is
secure and fully engaged in the
catch.
Make sure that the tether strap
tightening mechanism remains
accessible when the seat back is fully
engaged in the catch.
Upper (top tether) anchorages - Super
Cab
WARNING: child restraint
anchorages are designed to
withstand only those loads imposed
by correctly fitted child restraints. Under
no circumstances are they to be used for
adult seatbelts, harnesses or for attaching
other items or equipment to the vehicle.
There are two child restraint anchor fittings
on the rear panel of the Super Cab, one
behind each rear seating position in the
locations shown.
17
WARNINGS
WARNING