Table of Contents
Advertisement
Log in webpage, and configure alarm input and alarm output in alarm setting.
The alarm input in the webpage is corresponding to the alarm input end of the I/O port.
There will be high level and low level alarm signal generated by the alarm input device
when alarm occurs, set the input mode to "NO" (default) if the alarm input signal is logic
"0" and to "NC" if the alarm input signal is logic "1".
The alarm output in the webpage is corresponding to the alarm output end of the device,
which is also alarm output end of the I/O port.
Mode B
3
Quick Start Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the IPC-HFW3841E-AS-0280B-S2 and is the answer not in the manual?