Installing The Wp-120 Xga Line Transmitter; Wiring The Cat 5 Line In / Line Out Rj-45 Connectors; Figure 3: Cat 5 Pinout; Table 3: Cat 5 Pinout - Kramer WP-120 User Manual

4.3 Installing the WP-120 XGA Line Transmitter

To install your WP-120 XGA Line Transmitter:
1. Connect the line out RJ-45 connector of the transmitter to the pre-installed
UTP wiring in the wall box opening that connects via UTP cabling to the
LINE IN RJ-45 connector of the WP-120.
2. Connect your 12V DC power supply to the POWER SUPPLY pins
taking care that polarity is correct.
3. Insert the WP-120 directly into the wall box opening, and then mount the
front panel securely using the screws.
4. Connect the XGA acceptor to the XGA OUT HD15F connector.

4.4 Wiring the CAT 5 LINE IN / LINE OUT RJ-45 Connectors

Table 3 and Figure 3 define the CAT 5 PINOUT, using a straight pin to pin
cable with RJ-45 connectors:

Table 3: CAT 5 PINOUT

EIA /TIA 568A
PIN Wire Color
1 Green / White
2 Green
3 Orange / White
4 Blue
5 Blue / White
6 Orange
7 Brown / White
8 Brown
Pair 1 4 and 5
Pair 2 3 and 6
Pair 3 1 and 2
Pair 4 7 and 8
1 Connect the wire labeled "+" to the +12V pin, and the wire labeled "–" to the GND pin
Your WP-120 XGA Line Receiver
EIA /TIA 568B
PIN Wire Color
1 Orange / White
2 Orange
3 Green / White
4 Blue
5 Blue / White
6 Green
7 Brown / White
8 Brown
Pair 1 4 and 5
Pair 2 1 and 2
Pair 3 3 and 6
Pair 4 7 and 8

Figure 3: CAT 5 PINOUT

1
,
5