Configure Ip Parameters - Minolta PageWorks Pro 18 User Manual

6.3 Running Telnet
The Configuration Utility
Unit Serial no. 460121 V5.04
Main Menu
1. IP Parameters
2. LPD Printers
3. Protocols
4. Reset Unit
5. Restore Factory Defaults
6. Change Password
E. Exit
4. To end your Telnet session, type
made any changes you are prompted to either Save Changes and
Exit or Exit Without Saving Changes. Choose your option and
press .
Enter
Note
• Press to access the Telnet help utility.
?

6.3.2 Configure IP Parameters

Although the NIC must have an IP address before a Telnet Connection
can be made, you can use the utility to change the address or the other
IP parameters. The NIC will automatically initiate a soft reset when the
IP address change is sensed.
Note
• This will cause the Telnet connection to be broken. It is advisable to
make all other desired changes before changing the IP address.
1. At the Main Menu, type
Parameters menu (shown on the next page).
6-40
at the Main Menu. If you have
E
1 and press to bring up the IP
Enter