Advertisement
Chapter 6
7.
Hold the new cleaning pad by its tab and place the white side
against the orange roller closest to the green felt strip. Align
the center rib of the cleaning pad with the triangle on the green
felt strip.
8.
Keep the white side of the pad touching the orange roller
closest to the green felt strip as you press the pad forward and
down into the slot under the green felt strip. It's in place when
it clips securely into the slot with the white pad touching the
orange roller.
9.
Snap the separator pawl unit closed.
10. Pull open the spring latch on the outer edge of the oil bottle
retainer, and lift the retainer up and toward the center of the
printer (fig. 2.19).
NOTE: Normally, a little oil remains in the fuser slot in which
the oil bottle rests, and the spout of the oil bottle has a seal to
prevent oil from spilling while you remove or install a bottle
6 - 1 4
C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e
Advertisement
