Advertisement
5.
Locate the cleaning pad in the slot above the heat roller. Then,
while carefully avoiding the surface of the fuser unit, which
may be hot, grasp the pad by its center tab (towards the rear
of the unit), pull it out of the printer, and discard it (fig. 6.3).
Fig. 6.3 Remove the Cleaning Pad
6.
Remove the new cleaning pad and the new oil bottle from their
protective bags.
CAUTION: The $1000 fuser unit will be damaged if the cleaning
pad is not replaced each time the oil bottle is replaced. This type of
damage is not covered under warranty or service contract. Both
parts are included in the same kit.
C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e
Chapter 6
6 - 1 3
Advertisement
