Konica Minolta Magicolor 2350 EN Reference Manual page 47

Variable
Choices/
Range
Default 0
Description Selects the PCL font to be used for the current job. This
Variable
Choices/
Range
Default I
Description This variable identifies the source of the fonts to be used.
Variable
Choices/
Range
Default 2
Description Sets the line termination value.
Environmental Variables
LPARM:PCL FONTNUMBER
0-65535(dependent on FONTSOURCE and
SYMSET--see note)
variable is used with the FONTSOURCE variable to identify
the specific font to be used.
Font numbers start at 0 if a font is set as default;
otherwise, font numbering starts at 1.
The recommended order of setting the variables affecting
the font is SYMSET, FONTSOURCE, and then
FONTNUMBER.
LPARM:PCL FONTSOURCE
I
S
I — Internal Fonts
S — Permanent Soft Fonts
LPARM:PCL LINETERMINATION
0
1
2
3
0—CR=CR, LF=LF, FF=FF
1—CR=CR-LF, LF=LF, FF=FF
2—CR=CR, LF=CR-LF, FF=CR-FF
3—CR=CR-LF, LF=CR-LF, FF=CR-FF
43