Installing Printer Drivers And Software; Windows Using Tcp/Ip - MINOLTA-QMS Magicolor 2200 DP Installation Manual

Installing Printer Drivers and Software

Windows Using TCP/IP

TCP/IP Interface Configuration
Detailed instructions for configuring TCP/IP can be found in the CrownBook.
5 "
If you use DHCP to configure TCP/IP, you must enable DHCP/WINS in
Administration/Communications/Resident NIC/CrownNet/TCP/IP printer
configuration menu.
You can configure your print system by several different methods. This section briefly
describes the configuration procedure for the printer interface. You can make these
configuration changes through any of the following means:
„
Printer control panel
„
CrownAdmin 3 for Windows
„
Remote Console through a telnet session
1
If necessary, in the Administration/Communications/Resident NIC/CrownNet/
TCPIP/Internet Address menu, enter the printer's Internet address.
The factory default Internet address is 161.033.128.024.
2
If necessary, in the Administration/Communications/Resident NIC/CrownNet/
TCPIP/Default Router menu, enter the Internet address of the default router.
The factory default router address is 000.000.000.000. This setting provides
automatic sensing of gateways. If you identify a subnet mask, automatic sensing
is disabled.
3
If necessary, in the Administration/Communications/Resident NIC/CrownNet/
TCPIP/Subnet Mask menu, enter the printer's subnet mask.
The default subnet mask is 000.000.000.000.
TCP/IP Network Configuration
1
Log on the system as administrator.
42 Installing Printer Drivers and Software