Macintosh - MINOLTA-QMS Magicolor 2200 DP Installation Manual

9
Type in the Host Address, or Host Name, and Printer Name.
5 "
The default is "Passthrough."
The new Printer Agent loads.
10
If you choose, select the printer driver for each client workstation and click
Continue.
The main browser window appears listing your new controlled access printer.

Macintosh

EtherTalk Interface Configuration
You can configure your MINOLTA-QMS print system by several different methods.
This section briefly describes the configuration procedure for the printer interface. Refer
to your printer documentation for detailed instructions. You can make these configuration
changes through any of the following means:
„
Printer control panel
„
CrownAdmin 3 for Macintosh
„
Print Utility for Macintosh
„
Remote Console
„
CrownView
When your printer boots up, it will find a default zone. If your network has more than one
zone, use the Administration/Communications/Resident NIC/CrownNet/EtherTalk/Zone
Name/Zone Part 1 and Zone Part 2 menus to enter the name of the zone to which the
printer is attached.
5 "
The two Zone Part x menus allow you to identify 1 zone with a name up to 32
characters long. (Up to 16 characters can be entered in each of the two menus). You
cannot use these two menus to identify two zones. Trailing spaces are not considered
part of the zone name. All standard printable ASCII characters are valid except the
@ and ' symbols. The names are case sensitive.
48 Installing Printer Drivers and Software