Advertisement
General safety instructions
DANGER
Risk of asphyxiation. Keep pack-
aging film out of the reach of children.
WARNING
Only use the device for its proper
use. Take into account the local conditions and beware
of third parties, in particular children, when working with
the device.
The device is not intended for use by per-
sons with restricted physical, sensory or mental abilities
or those lacking in experience and / or lacking in knowl-
edge.
Only people who have been instructed on how
to use the device, or have proven their ability to operate
it, and have been explicitly instructed to use it, must use
the device.
Children must be supervised to prevent
them from playing with the appliance.
minors must not use the device.
CAUTION
Safety devices are provided for
your own protection. Never modify or bypass safety de-
vices.
Risk of electric shock
DANGER
Only connect protection class I de-
vices to properly earthed power sources.
indicated on the type plate must match the voltage of
the power source. Take into account the minimum pro-
tection required for the socket, see chapter Technical
data in the operating instructions.
device via a fault current protection switch (maximum
30 mA).
Never touch the mains plug and socket with
wet hands.
The mains plug and coupling of the exten-
sion cable must be water tight and may not be placed in
water. The coupling may not be on the floor. Use cable
drums to ensure that the sockets are at least 60 mm
above the floor. All live parts in the work area must be
protected against water jets.
WARNING
Only connect the device to an
electrical connection which has been set up by a quali-
fied electrician as per IEC 60364-1.
supply cable with mains plug for damage before opera-
tion each time. Do not put the device into operation with
a damaged power supply cable. Have a damaged pow-
er supply cable replaced immediately by the authorised
customer service / qualified electrician.
age the power supply and extension cable by running
over it, crushing or yanking it or similar. Protect the pow-
er supply cable from heat, oil and sharp edges.
use the mains connection cable prescribed by the man-
ufacturer, including when replacing the cable. For order
no. and type see operating instructions.
electrical extension cables can be dangerous. Only use
approved and appropriately marked electrical extension
cables with a sufficient cable cross section for outdoors.
Only replace couplings on the power supply or exten-
sion cable using those with the same water density and
the same mechanical strength.
CAUTION
In case of longer breaks in opera-
tion and after use, switch off the device at the main
switch / device switch and pull the mains plug.
ATTENTION
Switch-on procedures will gener-
ate short-term voltage drops.
conditions may cause other devices to be impaired. In
case of a network impedance of less than 0.15 ohms,
no malfunctions are to be expected.
Children and
The voltage
Only operate the
Check the power
Do not dam-
Only
Unsuitable
Unfavourable mains
Water connection
WARNING
The device must not be started
up if the high-pressure hose is damaged. Replace a
damaged high-pressure hose at once. Only those
hoses and connections recommended by the man-
ufacturer may be used. For order no. see operating
instructions.
The screw connections of all connection
hoses must be leak-tight.
ATTENTION
Observe the regulations at your
water distribution company.
Operation
DANGER
When using the device in hazard
zones (e.g. service stations), adhere to the respective
safety regulations.
Operation in explosive atmos-
pheres is prohibited.
Never suction solvents, liquids
containing solvents or undiluted acids. This includes
e.g. petrol, paint thinner or heating oil. The spray mist is
highly flammable, explosive and poisonous.
aged wheels / tyre valves are extremely dangerous.
Damaged wheels / tyre valves can be damaged by the
high-pressure jet and explode. The first sign of this is
discolouration of the tyres. Keep a spray distance of at
least 30 cm when cleaning the wheels / tyre valves.
WARNING
Do not use the device if people
without the proper protective clothing are in its reach.
With short spray lances, your hand may come into
contact with the high-pressure jet. Never use a spotlight
nozzle or rotary nozzle with steel tubes that are shorter
than 75 cm.
A recoil force will arise due to the water
stream ejecting from the spray lance. An angular spray
lance produces a force that acts in upward direction.
Make sure you grip the gun and spray lance firmly.
When using angular spray units, recoil forces and
twisting forces may alter.
sure jet at yourself, e.g. to clean clothes or shoes.
not direct the high-pressure jet at persons, animals, live
electrical equipment or at the device itself.
spray any objects which contain harmful substances
(e.g. asbestos).
Check the device and the accesso-
ries, such as the high-pressure hose, high-pressure gun
and safety devices, to make sure they are in proper safe
and reliable condition before each operation. Do not use
the device if it is damaged. Replace damaged compo-
nents immediately.
Only use high-pressure hoses,
control panels and couplings specified by the manufac-
turer.
CAUTION
Never leave the device unsuper-
vised while it is in operation.
while the motor is running.
the high-pressure gun during operation.
hoses to cool down after hot water operation or operate
the device briefly using cold water operation.
vice must be placed on an even, firm subsurface.
fore cleaning, carry out a risk assessment of the surface
to be cleaned to determine any health and safety pro-
tection requirements. The necessary protective meas-
ures must be taken accordingly.
ATTENTION
Do not operate the device at tem-
peratures below 0 °C.
ing stations with an oil separator.
Operation with detergent
CAUTION
Keep the detergent out of the
reach of children. When using detergents, observe the
safety data sheet of the detergent manufacturer, in par-
Dam-
Do not aim the high-pres-
Do not
Never open the cover
Never clamp the lever of
Allow the
The de-
Only clean the motor at wash-
Do
Be-
Advertisement
