Slow & Fast Motion Recording - Canon XA70 Instruction Manual

4k camcorder

Table of Contents

Slow & Fast Motion Recording

You can record clips that have a slow motion or fast motion effect during playback, simply by selecting the

desired slow/fast motion rate. Available slow/fast motion rates will vary depending on the resolution and frame

rate currently selected. Sound is not recorded when slow & fast motion recording is activated.

Operating modes:

1 Select [Slow & Fast Motion].

> [3 " Recording Setup] > [Slow & Fast Motion]

2 Select the desired slow & fast motion rate and then select [X].

• Select [j] to turn off slow & fast motion recording.

•

and the selected rate will appear on the right of the screen.

MP4 clips: Available slow/fast motion rates

Resolution

3840x2160

1920x1080

1280x720

XF-AVC clips: Available slow/fast motion rates

Resolution

3840x2160

1920x1080

NOTES

• Slow & fast motion recording cannot be used together with the following functions.

- Dual recording

- Relay recording

• While slow & fast motion recording is activated, the recording command signal will not be output from the

SDI OUT terminal (z only) or HDMI OUT terminal.

• About the time code when slow & fast motion recording is activated:

- The time code mode can be set to [

- If the time code running mode was set to [

automatically to [

- When slow & fast motion recording is turned off, the time code running mode will return to its previous

setting.

- The time code signal cannot be output from the SDI OUT terminal (z only) or HDMI OUT terminal.

• The maximum continuous recording time of a single clip using slow motion recording is the equivalent of 6

hours of playback time. Recording will stop automatically after that. For example, when the [x0.5] rate is

selected, the maximum continuous recording time will be 3 hours (which, played back at x0.5 slow motion,

equal 6 hours of playback time).

This restriction does not apply to fast motion recording, which will not stop automatically.

Frame rate

29.97P