Canon XA70 Instruction Manual page 130

Troubleshooting
When a subject flits across in front of the lens, the image appears slightly bent.
- This is a phenomenon typical of CMOS image sensors. When a subject crosses very quickly in front of the camcorder,
the image may seem slightly warped. This is not a malfunction.
Changing the operating mode between recording (Ü)/record standby (Ñ)/playback (Ð) takes longer than usual.
- When the SD card contains a large number of clips, some operations may take longer than usual. Save your
130
recordings (A 119) and initialize the card (A 32). Alternatively, replace the card.
Clips or photos cannot be recorded properly.
- This may occur as clips and photos are recorded/deleted over time. Save your recordings (A 119) and initialize the
card (A 32).
After using the camcorder for a long time, it becomes hot.
- The camcorder may become hot after using it continuously for long periods of time; this is not a malfunction. If the
camcorder becomes unusually hot or it becomes hot after using it only for a short while, it may indicate a problem with
the camcorder. Consult a Canon Service Center.
Playback
Cannot delete clips/photos
- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.
- Photos that were protected using other devices cannot be deleted with this camcorder.
- You may not be able to delete clips recorded or edited using another device.
Deleting clips takes longer than usual.
- When the SD card contains a large number of clips, some operations may take longer than usual. Save your
recordings (A 119) and initialize the card (A 32).
Cannot copy clips/photos
- You may not be able to copy clips/photos recorded or edited using another device and then transferred to a card
connected to the computer.
- There is not enough available space on the destination card or it already contains the maximum number of XF-AVC
clips (999 clips). Delete some XF-AVC clips (A 107) to free some space or replace the card.
Cannot mark individual clips/photos in the index screen with a checkmark !
- You cannot select more than 100 clips/photos individually. Select the [All Clips] or [All Photos] option instead of
[Select].
Indicators and Onscreen Displays
appears in red on the screen.
- Battery pack is depleted. Replace or charge the battery pack.
í appears on the screen.
- The camcorder cannot communicate with the battery pack attached so the remaining battery time cannot be
displayed.
The tally lamp does not illuminate.
> [System Setup] > [Tally Lamp] to [On].
- Set
The tally lamp flashes quickly.
- The battery pack is depleted. Replace or charge the battery pack.
- There is not enough available space on the card. Delete some recordings (A 107) to free some space or replace the
card.
6 / 7 (in red) and [End] appear on the screen.
- The SD card is full. Delete some recordings (A 107) to free some space or replace the card.
/ appears in red on the screen.
- A card error occurred. Turn off the camcorder. Remove and reinsert the card. Initialize the card if the display does not
change back to normal.
Even after stopping recording, the ACCESS indicator stays illuminated in red.
- The clip is being recorded on the card. This is not a malfunction.
(4 flashes per second)