Settings Data/Backing Up Or Restoring Logs [Data] - i-PRO WV-SUD638 Operating Instructions Manual

15 Maintenance of the camera [Maintenance]
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
[Position refresh]
The camera position can be refreshed. When the camera has moved from the correct home/preset position
during normal use, or when it has been inadvertently moved while turning on the power of the camera, use
this function to correct the camera position. It is impossible to operate the camera during the position refresh
process (for about 2 minutes).
IMPORTANT
•
The direction of the camera may be accidentally changed when the camera is installed. When
registering presets after the installation, we recommend performing position refresh.
Note
•
Position refresh will not operate during washer operations and when learning patrol operations.
•
To initialize the network settings (®page 126), turn off the power of the camera, then turn on the power
again while holding down the INITIAL SW on the unit, and keep the INITIAL SW held down for more
than 10-15 seconds. Wait about 2 minutes after releasing the button. The camera will start up and the
settings including the network settings will be initialized. Do not turn off the power of the unit about 3
minutes after turning on the power.
15.5 Settings data/backing up or restoring logs
[Data]
Click the [Data] tab of the "Maintenance" page. (®page 32, page 34)
The settings related to backing up or restoring settings data, and saving logs can be configured in this section.
188 Operating Instructions