Table of Contents
Advertisement
7 Configure the basic settings of the camera [Basic]
[Alarm status reception port]
When selecting "Real time" for "Alarm status update mode", designate a port number to which the status change
notification is to be sent.
•
Available port number: 1 - 65535
•
Default: 31004
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[Viewer software (nwcv4Ssetup.exe)] - [Automatic installation]
Determine whether or not to install the viewer software from this camera.
•
On: Installs the viewer software from the camera automatically.
•
Off: The viewer software cannot be installed from the camera.
•
Default: On
IMPORTANT
•
It is impossible to display images and to receive audio between the camera and the PC when the viewer
software "Network Camera View 4S" is not installed on the PC.
•
The number of the viewer software installations can be checked on the [Upgrade] tab of the
"Maintenance" page.
[Viewer software (nwcv4Ssetup.exe)] - [Smoother live video display on the browser
(buffering)]
Perform settings to display camera images on the viewer software.
•
On: Images are temporarily stored on the computer and are displayed smoother.
•
Off: Images are displayed in real-time and are not stored on the computer.
•
Default: Off
[Viewer software (nwcv4Ssetup.exe)] - [Contrast enhancement (RGB:0 to 255)]
Select "On" or "Off" to determine whether or not to enhance the contrast of H.264 images on the "Live" page.
If "On" is selected, the range of RGB signal on display is extended from 16-235 to 0-255.
When there is a bright part in an image, the intensity may be overexposed.
•
Default: Off
Note
•
This setting is only available when viewing images on the "Live" page with Internet Explorer.
•
Even if this setting is changed, transmitted image data is not changed.
[Relay output]
•
On: Connects the contact points of the "-" and "+" relay pins.
•
Off: Disconnects the contact points of the "-" and "+" relay pins.
•
Washer control: Makes it possible to control relay line switch according to the washer control settings.
"Relay output" is set to "On" at the start of the period set in "Pulse width" and is set to "Off" at the end of
period set in "Pulse width". When "Washer control" is selected, a link to "Washer control >>" is displayed.
(®page 43)
•
Default: Off
Note
•
Refer to page 43 for information on washer settings.
42
Operating Instructions
Advertisement
Table of Contents
