Snapper XD ESXD20S82K User Manual page 17

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
■ Remove and discard the old scraper.
■ Install the new scraper and fasten
it securely with 5 screws previously
removed.
REPLACE THE AUGER
(See Figure 13)
WARNING
Use only approved replacement scrap-
ers.
■ a. Remove the 5 screws (25) and side
wear pad (27) that secure the right side
cover (34).
■ b. Remove the nut (28) from the right
end of the axle (35).
■ c. Remove the 5 screws (25) that secure
the left side cover (36).
■ d. Remove the belt (29).
■ e. Lock auger (7) in place so it cannot
spin.
■ f. Using a socket wrench, turning
clockwise remove the large pulley nut
(28) and pulley (30).
■ g. Remove the 5 screws (25) that secure
the left side cover (36).
■ h. Remove the spacer (38) and wave
washer (39) from both sides of the axle
(35).
■ i. Remove the axle (35), which will come
out the left side of the unit, and remove
the old auger (7) from the front.
■ j. Install the new auger (7) and replace
the axle (35) with corresponding nut
(28).
■ k. Reinstall the right side cover (34) with
the 5 screws (25).
■ l. Reinstall the left side plate (37) with
the 5 screws (25), large pulley (30) with
the left side nut (28), belt (29), and left
side cover (36) with the 5 screws (25).
English (original instructions)
STORE THE MACHINE
■ Clean the machine before storage.
■ Make sure the motor is not hot when you
store the machine.
■ Make sure that the machine does not
have loose or damaged parts. If it is
necessary, do these steps/ instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved
service center.
■ Store the machine in a dry area.
■ Make sure that children cannot come
near the machine.
16