Snapper XD ESXD20S82K User Manual page 14

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
INSTALL THE UPPER HANDLE
(See Figure 2)
■ Align the holes in the middle handle (4)
and the upper handle (3).
■ Put the bolts (14) through the holes.
■ Tighten the handle knobs (13) onto the
bolts.
■ Do the same operation on the other
side.
INSTALL THE CHUTE DEFLECTOR
(See Figure 3)
Replace with:
■ Align the tab (17) on the chute onto the
slot (18) on the chute deflector (1) on
one side.
■ Once you have engaged one tab (17) on
one slot (18) push until you hear a click.
Repeat on other side.
■ Adjust the chute deflector (1) to engage
teeth on the back of the chute
■ Make sure that the tabs (17) engage the
slots (18) on the two sides.
■ Make sure that the posts (19) engage
the holes (16) on the two sides.
INSTALL THE CHUTE CONTROL ROD
(See Figure 4-5)
■ Align the holes in the upper chute
control rod (20) and lower chute control
rod (21).
■ Put the hitch pin (22) through the holes.
■ Align the arrows in the discharge chute
(9) and snow thrower deck. Make sure
the discharge chute (9) faces forward.
■ Put the end of the chute control rod
(12) straight through the hole (23) in the
bracket. Keep the grip handle down.
■ Push the chute control rod (12) into the
hole (23) behind the deck.
■ Turn the grip handle left and right to
make sure that the discharge chute (9)
English (original instructions)
moves in the same direction.
INSTALL THE BATTERY PACK
(See Figure 6)
■ If the battery pack or charger is
damaged, replace the battery pack or
the charger.
■ Stop the machine and wait until the
engine stops before you install or
remove the battery pack.
■ Read, know, and do the instructions in
the battery and charger manual.
■ Open the battery door.
■ Align the lift ribs on the battery pack
(24) with the grooves in the battery
compartment (5).
■ Push the battery pack (24) into the
battery compartment (5) until the battery
pack locks into place.
■ When you hear a click, the battery pack
(24) is installed.
■ Close the battery door.
REMOVE THE BATTERY PACK
(See Figure 6)
■ Open the battery door.
■ Push and hold the battery release
button.
■ Remove the battery pack (24) from the
machine.
OPERATION
Wear eye protection during operation.
COLD WEATHER OPERATION
The safe battery operation temperature
ranges from 1°F (-17°C) to 113°F (45°C).
13
WARNING
WARNING