Table of Contents
Advertisement
Setup Software
(continued)
8
MAC ADDRESS
Displays the MAC addresses of remote cameras with links set with camera numbers of this unit.
z These are displayed when they are acquired with [AUTO IP SET] on the main unit or with [AUTO IP CAM ASSIGN] on this software.
z
9
IP ADDRESS
Set the IP address of the remote camera that will be the connection destination.
10 CAMERA PORT NO
Set the port number of the remote camera that will be the connection destination.
After input, click the [SAVE] button to reflect the changed content.
Settable range: 1 to 65535
However, even within this range, the following values cannot be set.
20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162, 995, 10669, 10670
11 SWAP CAMERA
You can switch the remote camera set as the connection destination between 2 camera numbers.
Camera numbers [CAM1] to [CAM200] are displayed when
For remote cameras selected as [Serial] in [CNTRL TYPE], you can swap in the range between [CAM1] and [CAM5].
12 RENEW button
Executes the AUTO IP (RENEW IP ADR) function of the unit. Then, among the camera numbers of the remote cameras newly detected by the unit,
those that can be used to set up connections to the unit are displayed in yellow.
When pressing the SET button, the setting is complete and updated.
13 KEEP button
Executes the AUTO IP (KEEP IP ADR) function of the unit. Then, among the camera numbers of the remote cameras newly detected by the unit,
those that can be used to set up connections to the unit are displayed in yellow.
When pressing the SET button, the setting is complete and updated.
14 REFRESH button
Displays the connection information set in the unit on the [Setting] screen.
15 ALL CLEAR button
Clear all setting data.
16 SET button
Reflects the set data to AW‑RP60.
17 CANCEL button
Cancels the settings.
is clicked.
75
Advertisement
Table of Contents
