Troubleshooting; Malfunction Table; Replacing The Bulb In The Oven Ceiling Light; Glass Cover - Bosch HGV52D123Q Instruction Manual

:
Risk of injury!
Scratched glass in the appliance door may develop into a crack.
Do not use a glass scraper, sharp or abrasive cleaning aids or
detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
1. Insert the panel at an angle towards the back (fig. A).
2. Insert the top panel at an angle towards the back into the
brackets. The smooth surface must face outwards. (fig. B).

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If your meal is not successful, please refer to section
tested the recipe for you in our cooking studio
useful cooking tips and tricks for cooking, baking and roasting.
:
Risk of electric shock!
Repairs that are not carried out properly are dangerous. Repairs
must only be performed by one of our after-sales service
technicians.
Malfunction Possible cause
The oven does The circuit
not work. breaker is defec-
tive.
Power cut.
Oven not hot. Dust on the con-
tacts.
The burner does Power has failed
not ignite. or ignition plugs
are damp.
. We have
. Here, you will find
Remedy/information
Look in the fuse box to see if
the circuit breaker is defec-
tive.
Check whether the kitchen
light and other kitchen appli-
ances are working.
Turn the control knobs sev-
eral times to the left and
right.
Light the gas burner with a
gas lighter or a match.
$
3. Put the cover back in place and press on it.
4. Attach the oven door.
Do not use the oven again until the panels have been correctly
installed.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
1. Place a tea towel in the oven when it is cold to prevent damage.
2. Unscrew the glass cover by turning it anti-clockwise.
3. Replace the bulb with one of the same type.
4. Screw the glass cover back in.
5. Remove the tea towel and switch on the circuit breaker.

Glass cover

You must replace a damaged glass cover. Suitable glass covers
may be obtained from the after-sales service. Please specify the
E number and FD number of your appliance.
%
63