Irq Resources - JETWAY 650EM User Manual

make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
Reset Configuration Data
Resources Controlled By
> IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
↑↓→← Move Enter:Select
F5:Previous Values
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system can not boot. The
settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and
Plug and Play compatible devices. However, this capability means absolutely nothing unless
you are using a Plug and Play operating system such as Windows
to "manual" choose specific resources by going into each of the sub menu that follows this
field (a sub menu is preceded by a ">").
The settings are: Auto(ESCD), Manual.

IRQ Resources

When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
Please refer to section 3-9-1
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
3-9-1 IRQ Resources
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
IRQ-3 assigned to
IRQ-4 assigned to
PnP/PCI Configurations
Disabled
Manual
Press Enter
Disabled
Enabled
Enabled
+/-/PU/PD:Value F10:Save ESC:Exit
F6:Optimized Defaults
IRQ Resources
PCI Device
PCI Device
33
Item Help
Menu Level >
Default is Disabled.
Select Enabled to
reset Extended System
Configuration Data
(ESCD) when you exit
Setup if you have
installed a new add-on
and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot
F1:General Help
F7:Standard Defaults

95/98. If you set this field
Item Help