Table of Contents
Advertisement
These headers are used for connecting the additional USB port plug. By attaching an
option USB cable, your can be provided with two additional USB plugs affixed to the
back panel.
(4)
IDE Activity LED: HD-LED
This connector connects to the hard disk activity indicator light on the case.
(5)
Reset switch lead: RESET
This 2-pin connector connects to the case-mounted reset switch for rebooting your
computer without having to turn off your power switch. This is a preferred method of
rebooting in order to prolong the lift of the system's power supply. See the figure
below.
(6)
Speaker connector: SPEAK
This 4-pin connector connects to the case-mounted speaker. See the figure below.
(7)
Power LED: PWR-LED
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(8)
Power switch: PWR-BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
(9)
Wake On-LAN Headers (3-pin) : WOL
This connector connects to a LAN card with a WAKE ON-LAN output. This connector
power up the system when a wake up signal is received through the LAN/Modem card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
USB1
Pin 1
USB Port Headers
JW _ FP1
SPEAK
Pin 1
SPKR
HDLE D
NC
G ND
VC C5
RE SE T
System Case Connections
16
USB2
OC (Over Current)
Pin 1
USB Port Headers
Pin 1
VC C5
VC C 5
AC PILE D
HDDL E D
PWR BTN
G ND
RSTSW
G ND
NC
ACPILED
PWRBT
Advertisement
Table of Contents
