Table of Contents
Advertisement
Auto Detect DIMM/PCI Clock
Spread Spectrum
Clock Control
** Current Host Clock is 100/33MHz **
HOST/PCI Clock at Next Boot is
** Current DRAM Clock is 100 MHz **
DRAM Clock at Next Boot is
↑↓→← Move Enter:Select
F5:Previous Values
Auto Detect DIMM/PCI Clock
This item allows you to enable/disable auto detect DIMM/PCI Clock.
The settings are: Enabled, Disabled.
Clock Control
This item allows you to set the CPU Host Clock by Hardware (CPU/PCI 100/33MHz) or by
Software (BIOS)
Host/PCI clock at Next boot is
When Clock Control setting By Software this item allows you to set CPU Host Clock step by
step from 100MHz to 200MHz, use Page Down/Page Up key can change the frequency to
approach over clocking.
DRAM Clock at Next Boot is
This item allows you to set the DRAM clock synchronous as CPU Host Clock or
Asynchronous as Host clock 100MHz, 133MHz to approach your specification.
3-12 Load Standard/Optimized Defaults
Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message similar
to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance system
Enabled
Disabled
By Software
100/33MHz
100MH (HOST CLK)
+/-/PU/PD:Value F10:Save ESC:Exit
F6:Optimized Defaults
35
Menu Level >
F1:General Help
F7:Standard Defaults
Advertisement
Table of Contents
