Error Messages; Ieee 1394 Device Problems - Dell Vostro 420 Service Manual

4. Click Scan for and attempt recovery of bad sectors and click Start.
Windows Vista:
1. Click Start
2. Right-click Local Disk C:.
3. Click Properties® Tools® Check Now.
The User Account Control window may appear. If you are an administrator on the computer, click Continue; otherwise, contact your administrator to
continue the desired action.
4. Follow the instructions on the screen.

Error Messages

CAUTION:
safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
If the error message is not listed, see the documentation for the operating system or the program that was running when the message appeared.
A filename cannot contain any of the following characters: \ / : * ? " < > | —
A required .DLL file was not found —
Windows XP:
1. Click Start® Control Panel® Add or Remove Programs® Programs and Features.
2. Select the program you want to remove.
3. Click Uninstall.
4. See the program documentation for installation instructions.
Windows Vista:
1. Click Start
2. Select the program you want to remove.
3. Click Uninstall.
4. See the program documentation for installation instructions.
drive letter :\ is not accessible. The device is not ready —
Insert bootable media —
Not enough memory or resources. Close some programs and try again —
you may have to restart your computer to restore computer resources. If so, run the program that you want to use first.
Operating system not found —

IEEE 1394 Device Problems

CAUTION:
safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: Your computer supports only IEEE 1394a standard.
Ensure that the cable for the IEEE 1394 device is properly inserted into the device and into the connector on the computer
Ensure that the IEEE 1394 device is enabled in system setup —
Ensure that the IEEE 1394 device is recognized by Windows —
Windows XP:
Great user manuals database on
and click Computer.
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. For additional
The program that you are trying to open is missing an essential file. To remove and then reinstall the program:
® Control Panel® Programs® Programs and Features.
Insert a bootable CD or DVD.
Contact Dell (see Contacting
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. For additional
UserManuals.info
Do not use these characters in filenames.
The drive cannot read the disk. Insert a disk into the drive and try again.
Close all windows and open the program that you want to use. In some cases,
Dell).
See System Setup Program for assistance.