Removing The Base Cover; Replacing The Base Cover - Dell Studio 1745 Service Manual

Back to Contents Page
Base Cover
Dell Studio™ 1745/1747 Service Manual
Removing the Base Cover
Replacing the Base Cover
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
Removing the Base Cover
1. Follow the procedures in
2. Remove the battery (see
3. Remove the six screws that secure the base cover to the computer base.
4. Lift the base cover off the computer at an angle as shown in the following illustration.
1 screws (6)
3 tabs (4)
Replacing the Base Cover
1. Follow the procedures in
2. Align the four tabs on the base cover with the slots on the computer base and gently snap it into place.
3. Replace the six screws that secure the base cover to the computer base.
4. Replace the battery (see
Back to Contents Page
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
Before You Begin.
Removing the Battery).
2 base cover
Before You Begin.
Replacing the Battery).
UserManuals.info
Removing the Battery) before working inside the