Blind-Spot View Monitor (Bvm) - Hyundai Tucson 2023 Owner's Manual

Driver Assistance System
Left side
ONX4PH072017N
Blind-Spot View Monitor uses the wide-
side view cameras to display the rear
blind spot area of your vehicle on the
instrument cluster when the turn signal
is turned on.
Information
Refer to the "Driver Assistance Sensors"
section in this chapter for the location
and the general precautions of wide-side
view cameras.
Blind-Spot View Monitor
Settings
Blind-Spot View
With the ignition switch ON, go to
Setup > Vehicle > Driver Assistance >
Blind-Spot Safety > Blind-Spot View
(for infotainment system type) from the
Settings menu to turn on and off Blind-
Spot View Monitor.
7-64
Right side
ONX4PH072018N
Blind-Spot View Monitor
Operation
Turns on if:
The left or right side turn signal turns
on, the corresponding side view camera
image appears on the instrument cluster.
Turns off if:
The turn signal turns off, the image on
the instrument cluster turns off.
The hazard warning flasher is on.
Blind-Spot View Monitor turns off,
independent of the turn signal status.
Other warnings on the instrument
cluster may replace the side view
camera image when changing lanes.
Blind-Spot View Monitor
Malfunction
When Blind-Spot View Monitor is not
working properly, have the vehicle
inspected by an authorized HYUNDAI
dealer.
WARNING
Always turn your head and look to
determine if there is enough distance
to change lanes. The perceived
distance from another vehicle shown
on the instrument cluster may differ
from the actual distance.
Always keep the side view camera
lenses clean. If the lens is blocked or
covered, Blind-Spot View Monitor may
not operate normally. Do not clean
with strong chemicals containing high
alkaline or volatile organic solvents
(e.g. gasoline, acetone).