Subscribe to Our Youtube Channel
Related Manuals for MRC MIXP Series
Summary of Contents for MRC MIXP Series
- Page 1 MIXP-SERIES Table-top Double Movement Mixer Operation manual PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION 3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529 mrc@mrclab.com MRC.3.21 - 1 -...
-
Page 2: Table Of Contents
Catalogue 1.Important Precautions ······················································································ 2. Working principle, structure, scope of application ····································································· 2.1 Working principle ····················································································· 2.2 Whole machine structure ····················································································· 2.3 Technical Parameters ····················································································· 2.4 Scope of application ···················································································· 3. Precautions when receiving and keeping ········································································ 3.1 Received machine ··························································································... -
Page 3: Important Precautions
Important Precautions Welcome to use our advanced and energy-efficient table double movement mixer. For your better use of this equipment, please read this manual carefully before putting the equipment into operation. This manual has important instructions for operation. Please store the manual in a dry place on the accessories of the device so that it can be quickly obtained if you need to consult it. -
Page 4: Whole Machine Structure
2.2 Whole machine structure 1. Equipment nameplate 2. Machine skin 3. Barrel fixing fixture 4. Barrel 5. Barrel lid fixing fixture 6.Barrel lid 7. Spiral antler blade 8. Hour meter 9. Speed controller 10. Mains switch 2.3 Technical Parameters Barrel Barrel Blade Motor... -
Page 5: Precautions When Receiving And Keeping
laboratories, and corporate R&D centers. 3. Precautions when receiving and keeping 3.1 Received machine 3.1.1 Before the shipment of the company, the Supply project were carefully checked for completeness (installed and unmounted parts). 3.1.2 When the user received the goods, please carefully check the goods for damage. If any parts are found to be damaged, please immediately complain to the shipper and inform us at the same time. -
Page 6: Commissioning Precaution
6.1.4 Turn on the power switch, press "run", slowly turn the knob switch to maximum, (MIXP adjust the frequency of the inverter), observe whether the machine is running smoothly. 6.1.5 Operate the machine for at least one half hour under no-load conditions to ensure whether exist abnormal heat, vibration, and abnormal noise. -
Page 7: Loading
7.3 Loading First, turn the machine head to this position, install the blade on the machine head, tighten the blade fixing bolts, and then install the bucket on the machine head and press the barrel fixing jig, as shown in the above figure. Put the material into the bucket, the best loading capacity is 70%~80% of the bucket volume. -
Page 8: Run
rocker switch press ‘stop’; 7.6 Run Turn on the power, press the power switch, and then press the "run" of the speed controller rocker switch, and then slowly turn knob switch to the setting speed. 7.7 Discharge material When the mixing time end, the equipment automatically stops, adjusts the direction of the drum outlet so that the outlet port is at the lowest position, and then the power switch is turned off. -
Page 9: Reducer
the equipment is in operation, please inform the manufacturer to adjust or replace the seal. 8.3 Reducer Reducer maintenance, replace the new engine oil after 100 hours the first cumulative use, and then replace it every six months. - 9 -...
Need help?
Do you have a question about the MIXP Series and is the answer not in the manual?
Questions and answers