Bijur Delimon L2P Manual

L2P Lubricator
manual, One Shot
Operation
The L2P Lubricator is of the spring discharge type. it is operated by pulling the knob which raises a
piston and compresses a spring. Releasing the knob automatically discharges oil into the system. Oil
viscosity does not affect discharge volume, but may affect system pressure.
Technical Data
Reservoir Capacity
Viscosity range
Lubricator Inlet Filter
Discharge Pressure
Discharge Volume Per Stroke
Notes Regarding Use
1. The lubricator inlet filter should be inspected periodically and cleaned/replaced as required.
2. discharge pressure will decrease as discharge volume decreases and the number of meter units
in the system increases.
System & Limitation
use Type F meter units. do not exceed 60 meter units. To calculate system flow (ø), refer to
Bijur Engineering Manual.
Maximum Permissible Total System Flow (ø)
Meter Units (#) CC Per Shot
1
5 240
10 170
15 140
20 115
25 100
30 85
40 60
50 57
60 ---
Startup Instructions
1. Fill reservoir with oil.
2. Start machine and see that oil flows freely at all bearings.
1
200cc
100 to 10,000 SSu at operating temperature
40 micron particle separation
30 psi average
1 or 2cc, factory set as specified on customer's order
2
450
320
250
210
180
150
120
90
60
BIJUR DELIMON INTERNATIONAL
(919) 465 4448 LOCAL
(800) 631 0168 TOLL-FREE
(919) 465 0516 FAX
www.bijuRdELimOn.COm
2100 Gateway Centre blvd., Suite 109
morrisville, nC 27560
24797 • R3 10/08