Table of Contents
Advertisement
4.2
Input and output signals
Connection
PIN 3
PIN 4
PIN 29
PIN 30
PIN 31
PIN 32
Connection
PIN 17 / 19
PIN 18 / 20
Connection
PIN 11
Connection
PIN 8
PIN 1
Page 13 of 37
Supply
Power supply (see technical data)
0 V (GND) Power supply.
Attention, PIN 4 and PIN 11 are connected internally.
Power supply for the power stage, only active in S1 version.
0 V (GND) supply connection for the power stage, only active in S1 version.
Power supply for the extension
0 V (GND) supply connection for the extension
PWM output
Current controlled PWM outputs for solenoid A.
Current controlled PWM outputs for solenoid B.
Analogue input signals
0 V reference for the signal in- and outputs.
Digital inputs and outputs
Enable Input:
This digital input signal linked with the software enabling initializes the application.
READY output:
ON:
Module is ready, no errors are detected
OFF:
ENABLE is deactivated or an error was detected.
board, in S1 version only for the Profibus interface.
board, in S1 version only for ProfibusDP.
PAM-199-P-PDP
05.06.2020
Advertisement
Table of Contents
