C–4
Model 2100 and 2200 Ultra SCSI Controller Enclosures User Guide
Complete the procedure in Table C–2 to connect the Ultra SCSI bus cables.
1.
Connect the bus cable to the I/O module connector.
2.
Tighten two bus cable jackscrews.
3.
Connect the opposite end of the bus cable to a storage enclosure.
4.
Repeat steps 1 through 3 to connect other bus cables.
Host Cables
Refer to the array controller documentation for procedures on connecting the enclosure to
a host. Cable connection procedures might include:
Controller-to-controller
Controller-to-host
Installing the Power Supplies
Before installing the power supplies, read the following Caution and Note.
NOTE: Before applying AC power to the enclosure, completely configure the entire subsystem
(including the host and array controller cabling) as described in the appropriate publications.
Install all power supplies using Table 8–7.
Configuring the Enclosure
See Chapter 2 for general configuration rules. Then configure the array controllers using
array controller documentation.
Table C–2 Installing Ultra SCSI Bus Cables
CAUTION: The enclosure immediately turns O
the enclosure.
when AC source power is applied to
N