Stand Covers - Siemens MAMMOMAT Novation DR Manual

34
CAUTION
4. Fasten the front cover to the side covers with two short screws (see

Stand covers

WARNING
NOTE
Fig. 16: Mounting the stand covers
1. The covers are delivered with a protective plastic film, which should be removed and
discarded.
2. Make sure that clips are positioned over the holes where the screws (see
(1/Fig. 16 / p.
ers.
3. Fit left and right front covers (see
and contact washers (see
MAMMOMAT Novation DR
The front cover must not press against the collimator.
Risk of damage.
Be careful while attaching the front cover.
The edges of the metal curtain on the stand are very sharp.
They may cause severe injury.
Remove the protective strips carefully when the covers
are to be mounted. Store the strips in the holders pro-
vided on both sides of the curtain.
When mounting the stand covers, make sure that the screws at the
top of the stand are securely tightened and have functioning con-
tact washers.
These screws are used to establish protective ground connec-
tions.
34)) are to be fastened. These clips enable the screws to fasten the cov-
(3/Fig. 16 / p.
SPB7-250.815.06.02.02
12.05
Mechanical covers
(2/Fig. 16 / p. 34)) to the stand and fasten with screws
34)).
Page 34 of 116
CS SD 24
(5/Fig. 15 / p. 33)).
0
Siemens AG
Medical Solutions