Assembly; Contents; Attach The Control Box To The Caddy; Connect To A Power Source - Polaris iAquaLink CONTROL VTRX25iQ Owner's Manual

Page 6
3

Assembly

Contents

The packaging should contain the following items:
• Polaris cleaner and floating cable
• Control unit
• Storage & Transport Caddy (assembly
instructions separate)

Attach the Control Box to the Caddy

1. Align the bottom of the control box with the
notch at bottom of the control box hook on
the caddy (Figure 1).
Figure 1. Align Control Box with Caddy Hook
2. Press control box onto the caddy hook until
it snaps and locks into position (Figure 2).
Figure 2. Attach the Control Box onto Caddy

Connect to a Power Source

WARNING
Failure to comply with the following warnings
can result in permanent injury, electrocution or
drowning.
PREVENT ELECTRICAL SHOCK
• U.S.: Per NEC requirements, keep the control
®
box at least five 11.5 ft. (3.5 m) from the edge
of the pool. CANADA: Per CEC requirements,
keep the control box at least three 3m (10 ft.)
from the edge of the pool.
• Only connect the control box to a receptacle
protected by a ground fault circuit interrupter
(GFCI). Contact a certified electrician if you
cannot verify that the receptacle is protected by
a GFCI.
• Do not use an extension cord to connect the
control box.
• Do not allow anyone to swim while the cleaner
is in the pool.
• The control box is water-resistant, not
waterproof. In order to prevent electrocution,
never submerge the control box or leave
exposed to inclement weather.
1. Unscrew the protective cap for the floating
cable from the side of the control box by
turning counter-clockwise (Figure 3).
Figure 3. Remove Protective Cap