Section 2. 9300Xi Sport Specifi Cations; General Specifi Cations; Section 3. Assembly And Initial Usage; Unpacking - Polaris 9300xi Sport Owner's Manual

Page 6
Section 2. 9300xi Sport Specifi cations
2.1 General Specifications
The general specifi cations for the Polaris 9300xi Sport
are as follows:
Control box supply voltage
Polaris 9300xi supply voltage 30 V DC
Installed load
Cable length
Cleaner size (WxDxH)
Pack size (WxDxH)
Weight of Cleaner
Packed weight
Filtration
Cycle lengths
The Polaris 9300xi is a double-insulated product. A
double-insulated electrical appliance is one which has
been designed in such a way that it does not require a
safety connection to ground. The basic requirement for
double-insulation is that no single failure can result in
dangerous voltage becoming exposed so that it might
cause an electric shock and that this is achieved without
relying on an earthed (grounded) metal casing. This is
achieved by having two (2) layers of insulating material
surrounding live parts or by using reinforced insulation.
Therefore, devices having double-insulated construc-
tion, such as the Polaris 9300xi, do not utilize a ground-
ed (three-prong) cord/plug.
Section 3. Assembly and Initial
Usage

3.1 Unpacking

The packaging should contain the following items
(Refer to Figure 1):
• 9300xi Sport cleaner
• Control unit
• Remote control
• Transport and storage caddy (complete with
assembly components)
Check that the unit has not been damaged during
transport. If you detect damage, contact Zodiac Pool
Systems, Inc. at 1-800-822-7933 before using your
9300xi Sport cleaner.
9300xi Sport
100-125 VAC, 60 Hz
150 W max
70 ft (21 m)
16.9 x 18.9 x 10.6 in.
43 x 48 x 27 cm
22.8 x 22.8 x 23.2 in.
58 x 58 x 59 cm
25 lbs. (11.3 kg)
42 lbs. (19 kg)
less than 100 microns
1.30 hrs, 2.30 hrs.
Figure 1. Polaris 9300xi Sport Components
To unpack the 9300xi Sport and its components:
1. Remove the lower portion of the caddy along with
the upper and lower power cable hooks, control
unit hook, power cable hook plate, locking plate,
nuts, bolts and screws.
2 Remove the small box that contains the control unit.
3. Remove the handles (left and right) of the caddy,
which are located against one side of the box.
4. Remove the cleaner from the box.

3.2 Assembling the Transport Caddy

1. Position the power cable hook and control unit
hook on the upper tubes as shown in Figure 2.
Make sure the upper tubes (handles) are in the
proper orientation.
!
1
Figure 2. Install Hooks on the Upper Handles
X4
X1
X4
X2
X2
X1
X1
X1
2