Assembly; Contents; Connect To A Power Source - Polaris 7240 Sport Owner's Manual

Page 6
3

Assembly

Contents

The packaging should contain the following items:
• Polaris robotic cleaner and fl oating cable
• Control unit
• Control unit base
To protect the control unit from possible damage (which could lead to injury or property damage),
always secure the control unit to the control unit base during operation and storage.
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage during transport.
• If there are any missing parts or damage, contact Technical Support at
1-800-822-7933.

Connect to a Power Source

• Failure to comply with the following warnings can result in permanent injury,
electrocution or drowning.
• Prevent Electrical Shock
• U.S.: Per NEC
requirements, keep the control unit at least fi ve (5) ft. (1.5 m) from
®
the edge of the pool. CANADA: Per CEC requirements, keep the control unit at
least three (3) m (10 ft.) from the edge of the pool.
• Only connect the control unit to a receptacle protected by a ground fault circuit
interrupter (GFCI). Contact a certifi ed electrician if you cannot verify that the
receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control unit.
• Do not allow anyone to swim while the cleaner is in the pool.
• The control unit is water-resistant, not waterproof. In order to prevent electrocution,
never submerge the control unit or leave exposed to inclement weather.
WARNING