Classe Audio CP-500 Owner's Manual page 33

• If your preamplifier was plugged in properly, try the following:
Important! Make sure to power down your power amplifier BEFORE doing
the restart.
• If none of these solutions work, please consult your Classé dealer
3. Only one speaker seems to be playing.
• Check the main balance control setting of the CP-500 by
• Does the problem occur with all inputs? If so, check the
Important! Be certain that the power amplifier is off before checking any
connections between the preamplifier and power amplifier, or
between the speakers and the power amplifier.
• If the problem occurs only with a particular input, check the
• If the input balance appears to be correct, check the interconnect
4. The IR remote control seems not to function.
• Ensure that there are no obstacles between the IR remote and the
• If the batteries are weak, replace them with fresh ones.
put it in standby, switch off the main power switch in the back,
and unplug the unit for at least thirty seconds before trying to
power it up again. (Sometimes a brownout of short-term loss of
power might require a restart.)
for assistance. Never attempt to replace an internal fuse. There
are no user-serviceable parts inside your unit.
pressing the Menu button, followed by the balance button (or
simply press Bal on the remote control).
interconnect cables between the preamp and the power amp.
If no fault is found there, check the speaker wires for secure
connections.
input balance control setting of that particular input:
Menu ➝ system setup ➝ input ➝ input name ➝ balance
where input name is the particular input in question.
cables between the corresponding source component and the
CP-500.
IR sensor (located to the right of the Mute button).
33