Radio Flyer FLYER FOLDING CARGO Owner's Manual page 9

Step 2: Install kickstand
A. Unfold the bike frame until the front and rear frames are aligned.
B. Push the frame folding latch closed until you hear a click.
C. Make sure the bike is leaning against a stable surface with the left side of the bike
facing outward. Unscrew the bolt and washers from the top surface of the kickstand.
(Note: the kickstand has grease inside the joint that can stain clothing)
D. Align the kickstand in the bracket underneath the bike frame. Make sure the legs are
pointing towards the rear wheel. Reattach the lock washer on the bolt. Then, reattach
the washer on the bolt. Tighten the bolt by hand until it is too difficult to turn.
E. Check to make sure that the kickstand is fully seated inside of the rectangular
kickstand bracket. Tighten the kickstand bolt to 30 N-m using the 8mm allen wrench.
WARNING! Failure to secure the kickstand properly could cause it to fall off during riding.
A
D
B
E
C
9