Table of Contents
Advertisement
Step 4: Install handlebars
A.
Using the provided 5mm allen wrench, loosen the two stem clamp bolts.
B.
Place the center of the handlebar in between the stem clamps. Rotate the
handlebars with the headlight facing down until both top clamp bolts can be
accessed. Check to see that the cables are not twisted around the stem.
C.
Tighten both bolts by hand making sure the handlebar can still freely rotate.
D.
Rotate the plastic wire harness to the position depicted below. Make sure both
cable bundles are fed through the hooks under the plastic housing.
E.
Rotate the handlebar until the preferred position is achieved, checking to ensure
the handlebar is centered left-to-right within the stem clamp.
F.
Alternate tightening each bolt to 6 to 8 Nm to ensure an even gap on both sides of
the clamp.
Note: Complete assembly of the bike per the steps above. The stem and handlebar angle can be
adjusted as needed based on rider preference. Always re-tighten bolts to the specified torque values
prior to riding.
A
D
B
E
C
F
11
Advertisement
Table of Contents
