Table of Contents
Advertisement
Operation
Setting the Thermostat
Plug in the product and press the 'On' button. Press the 'Mode' button twice to enter
the thermostat mode. The current room temperature will be displayed (e.g. r23C)
followed by the current set point room temperature (e.g. 26C). Press the '+' and '-'
buttons to select your set point room temperature. Allow the display to turn off. Press
the 'Mode' button once to enter the 'Heat' option. Press the '+' and '-' buttons to select
either 'Low' or 'High' heat output. The heater will turn on when your set point room
temperature is higher than the room temperature.
Getting the Desired Flame Effect
1. Using the manual controls or the remote control choose a 'Fire' setting between F1
and F6, F1 being the lowest setting and F6 being the highest setting.
2. Generally the flames appear more realistic when the flame control is turned down.
3. Give the flame generator time to react to changes you have made.
4. The fire will use less water if the flame effect is set to a lower level.
5. Do not tilt or move the fire while there is water in the tank or sump.
6. Make sure that the fire is on a level floor.
Cleaning
Over time, dust can accumulate which can effect performance. It is recommended to
clean the unit at least once a month.
CAUTION: ALWAYS Turn the unit OFF and disconnect the appliance from the power
supply before undergoing any cleaning and maintenance.
The surfaces of the heater should be given an occasional wipe with a dry soft cloth. Do
not use detergents, abrasive cleaning powder or furniture polish as this can damage
the surface of the product.
The glass door should be cleaned carefully with a chamois leather. Do not use
proprietary cleaners.
To remove any accumulation of dust or fluff, the soft brush attachment of a vacuum
cleaner should occasionally be used to clean the outlet grille of the fan heater located
under the stoves main body.
14
Advertisement
Table of Contents
