Table of Contents
Advertisement
Installation
Installing the Appliance
1. Clean the area where the fire will be installed e.g. remove ash residue from an
existing fireplace.
2. Hold the fire by the sides of the surround and gently manoeuvre into position.
3. Plug the fire into a 10amp/230 volt outlet. Ensure that the supply cable is not
trapped under the fire such that it might cause it to be damaged.
Connecting the Transducer
1. Open the stove door.
2. Gently lift out the fuel bed and carefully set aside (Fig 4).
3. Remove the water tank by lifting upwards and outwards (Fig 5).
4. Remove the nozzle by unclipping and lifting upwards and outwards (Fig 6).
5. The transducer will be inside the sump. Remove from its bag.
6. Place the Transducer unit into the sump and make the connection.
7. Locate the tab on the Transducer unit into the moulded recess in the base of the
sump (Fig 7A).
8. Ensure that the cable does not obstruct the Transducer disc. To prevent the cable
becoming pinched between the nozzle and the sump, place the cable in the slot
in the wall of the sump (Fig 7B).
9
Advertisement
Table of Contents
