Table of Contents
Advertisement
Installation
Filling the Water Tank
1. Gently lift out the fuel bed and carefully set aside.
2. Remove the water tank by lifting upwards and outwards.
3. Place the water tank in the sink and remove the cap. Turn anti-clockwise to open
(Fig 8).
4. Fill the tank with filtered tap water only. This is necessary to prolong the life of
the flame and smoke producing unit. The water should be filtered through a con-
ventional domestic water filter unit and the filter should be replaced regularly.
5. Screw the cap back on, ensuring to not over-tighten.
6. Return the tank to the sump, with the tank cap facing down.
7. Gently place the fuel bed back into position.
Note: When the water tank is empty, the flame and smoke effect shuts off. You will
hear 2 audible beeps and the digital display will display
10
.
Advertisement
Table of Contents
