Manual Operation - Dimplex WLL20-AU Instruction Manual

Manual Operation

Operating Instructions
But- Display Func-
ton tion
A
Standby
trols fan
Thermo-
B
intensity
Setting/
C Tempera- Setting/
ture Temper-
Increase
Setting/
Setting/
D Tempera-
Temper-
ture
12
Description
Press this button once to turn on the product. Press it again to turn off the product.
When turned on, you will hear a beep and the digital display will show the 'ON,' icon,
On/ followed by displaying the current room temperature. The display will then turn off. The
main LED lights will activate. Be careful not to look directly into the LED's. Although
the mains lights operate immediately, it will take a further 45 seconds before the flame
effect starts.
Con- Press the 'Mode' button once for 'Heat' mode. The display will show the current
setting. Using the '+' and '-' buttons you can turn the heat on at the 'Low' or 'High'
setting and turn the heat off. You will hear 2 beeps for 'Low' heat setting and 3 beeps
heater
for 'High' heat setting. You will hear 1 beep when the heat is turned off.
Press the 'Mode' button twice for 'Thermostat' mode. The display will show the
current room temperature and then the set point temperature. Using the '+' and
stat '-' buttons you can adjust the set point temperature up and down. If the set point
temperature is below the room temperature, the heat function will not operate. The
temperature range is from 15-35°C.
Flame
Press the 'Mode' button three times for 'Fire' mode. The display will show the Fire
icon followed by the current fire effect setting. There are 6 fire settings. Using the '+'
and '-' buttons you can adjust the height of the flame effect.
De- Press this button to decrease the mode or temperature the device is currently
running on.
crease
ature
Press this button to increase the mode or temperature the device is currently running
on.
ature