About this document
1
About this document
1.1
Applicable Documents
All available documents for the product è www.festo.com/sp.
1.2
Specified standards
Version
DIN EN ISO 12100:2011-03
DIN EN ISO 4414:2011-04
DIN EN ISO 13849-1:2016-06
DIN EN ISO 13849-2:2013-02
Tab. 1
2
Safety
2.1
Safety instructions
–
Only use the product in original status without unauthorised modifications.
–
Only use the product if it is in perfect technical condition.
–
Observe labelling on the product.
–
Take into consideration the ambient conditions at the location of use.
–
Prior to mounting, installation and maintenance work: Switch off power supply and secure it from
being switched back on.
–
Observe tightening torques. Unless otherwise specified, the tolerance is ± 20 %.
The operating modes must guarantee that the residual risk is less than or equal to the accepted risk
è DIN EN ISO 12100. The measures for risk reduction must be implemented in accordance with
DIN EN ISO 4414, DIN EN ISO 12100 and DIN EN ISO 13849-1.
Monitor/check the function of the entire system during use in accordance with the measures defined
in the validation report è DIN EN ISO 13849-2.
4
Festo — DNCKE-...-S / KEC-...-S — 2020-10e