Table of Contents
Advertisement
I/O Panel: Dell OptiPlex 320 User's Guide
Back to Contents Page
I/O Panel
Dell™ OptiPlex™ 320 User's Guide
Removing the I/O Panel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
NOTE:
Note the routing of all cables before disconnecting them, so that you can re route them correctly when installing
the new I/O panel.
1. Follow the procedures in
2. Remove the cable from the I/O panel by pulling on the pull-loop.
3. Remove the screw that secures the I/O panel to the desktop computer.
NOTICE:
When sliding the I/O panel out of the computer, be extremely careful. Carelessness may result in damage to
the cable connectors and the cable routing clips.
4. Gently rotate and slide the I/O panel away from the computer.
1 securing screw
2 I/O panel
3 I/O cable connector
file:///N|/For_lekha/For%20Deepa/Nadia/UG/A00/en/nadia-temp-working-jul19/Nadia_UG_A00/Output/dt_iopan.htm[5/22/2015 10:44:02 AM]
Before You
Begin.
Advertisement
Table of Contents
