Table of Contents
Advertisement
Memory: Dell OptiPlex 320 User's Guide
1 cutouts (2)
2 memory module
3 notch
4 crossbar
NOTICE:
To avoid damage to the memory module, press the module straight down into the connector while you apply
equal force to each end of the module.
4. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
5. Replace the computer cover (see
6. The computer detects that the new memory does not match the existing configuration information and generates the
following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
7. Press <F2> to enter system setup and check the value for System Memory (see
The computer should have changed the value of System Memory to reflect the newly installed memory. Verify the
new total. If it is correct, skip to
8. If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets. Open
the computer cover (for desktops, see
Cover) and check the installed memory modules to ensure that they are seated properly in their sockets. Then repeat
step 5
through
step
9. When the System Memory total is correct, press <Esc> to exit system setup.
10. Run the Dell Diagnostics to verify that the memory modules are operating properly (see
Back to Contents Page
file:///N|/For_lekha/For%20Deepa/Nadia/UG/A00/en/nadia-temp-working-jul19/Nadia_UG_A00/Output/memory.htm[5/22/2015 10:43:53 AM]
Replacing the Computer
step
9.
Removing the Computer
7.
Cover).
System
Cover, for mini towers, see
Setup).
Removing the Computer
Dell
Diagnostics).
Advertisement
Table of Contents
