Mains Connection; Charging Lead; Correct Installation Of The Mains/Charging Cables - Fronius Selectiva 2060 Operating Instructions Manual

Mains connec-
tion
Danger from incorrect operation.
This can result in severe personal injury and damage to property.
▶
▶
▶
Danger due to faulty or insufficient power supply.
This can result in severe personal injury and damage to property.
▶

Charging lead

Danger due to trailing charging leads.
This may result in serious injury and damage to property. People may become en-
tangled in or trip over loose, unwound cables
▶
Danger due to the charging plug being pulled out during the charging process.
This may result in serious injury and damage to property. The sparks caused by
this can ignite the charging gases that build up during the charging process,
causing a fire or an explosion.
▶
Correct installa-
tion of the
mains/charging
Danger due to overheating caused by laying the mains/charging cables incor-
cables
rectly.
Risk of damage to the components.
▶
▶
▶
▶
▶
▶
12
WARNING!
Do not use the functions described here until you have fully read and under-
stood the following documents:
All the Operating Instructions for the system components, especially the
safety rules
Battery and vehicle manufacturer's Operating Instructions and safety rules
WARNING!
The power supply requirements detailed in "Technical data" must be met.
WARNING!
Lay the charging leads so that no one can trip over or become entangled in
them.
WARNING!
Once the charging process is complete, wind up the charging leads, or if
available, place them on the cable holder.
CAUTION!
Lay mains/charging cable without loops.
Do not cover mains/charging cable.
Charging cables longer than 5 m (16 ft. 4.85 in.) Lay cables individually (no
bundling).
Charging cables of more than 5 m (16 ft. 4.85 in.) Cables may have an in-
creased surface temperature (caution: hot surfaces).
In the following cases, ensure in particular that the surface temperature of
the charging cables does not exceed 80 °C (176 °F):
- Ambient temperature is 30 °C (86 °F) or more
- Cross-section of the charging cable is 95 mm
- Length of the charging cable is 5 m (16 ft. 4.85 in.) or more
The mains/charging cable may only be replaced by a qualified electrician.
2
or more