Rate Converter Controls - Analog Devices AD9789-EBZ Quick Start Manual

Quick Start Guide AD9789-EBZ
this counter is greater than zero, these Multiplier values should be adjusted. The counter should then be reset by cycling the switch to the
right of the count.

Rate Converter Controls

The Rate Converter will affect the frequency of the Frame Sync signal. If the rate converter
ratio is too large, certain modes that require many clock cycles may not be able to function.
The Center Frequency BPF should be set to center frequency of all active channels. This will
ensure that the band-pass filter is centered on where the carriers are.
Figure 18
Rev. A | Page 7 of 8