WACON AquaInform Sycon 2500 Operating Manual page 20

On-line water hardness monitor
Table of Contents

Advertisement

P
20
AGE
NOTE
or
NOTE
WARNING
ELECTRICITY
I
C
NSTALLATION AND
3.3 Installation in 4 steps
The analyser can be mounted with or without protective housing. The
manufacturer offers a standard housing; the mounting and dimensions are
described in this guide:
Custom-built or tailor made enclosures for the devices of the series aqua inform
LimitAnalyser / aqua inform TrendAnalyser / SYCON 2500 / SYCON 2800 and
SYCON 3000 as well as devices with custom names and labels that are
technically based on these ranges are not described in detail in this manual.
step I a
mounting without enclosure
Using 4 screws (max. 6 mm) to mount the unit on a wall or suitable support
structure. Hole spacing see page 24
step I b
Using the included 4 brackets to mount the unit (→ page 24). The tabs can be
rotated by 45 degrees or 90 degrees outside. Alternatively, the unit can be
mounted without the brackets from the rear on a plate (M6). For hole spacing see
page 24
In both variants, avoid direct sunlight and strong artificial light sources
→ disturbance of the optical path in the measuring chamber
→ electromagnetic interferences by artificial light source
Do not install under dripping pipes.
step II
eatablish sample and drain pipe line
Use flexible hose pipe 6x4. Between water treatment plant and analyser a
manual shutoff valve and particle filter (if necessary) should be installed.
Drainage should be lead via short connection into an open funnel → runoff to
atmospheric pressure.
Make sure that you connect the inlet and outlet properly
→ Figure 2.1 in page 13
step III electrical connections
refer to information in figure 3.1 (terminal connection (→ page 21) and figure 3.2
(connection instructions (→ page 22).
Work on electrical equipment of the plant / machinery must be performed by a
qualified electrician! Observe all applicable electrical installation work rules
→ applicable supply voltage 85 ... 264 V AC 47 ... 63Hz
OMMISIONING
mounting with enclosure
C
3
HAPTER
L
A
IMIT
NALYSER

Advertisement

Table of Contents
loading

This manual is also suitable for:

30-010120

Table of Contents